MailerQ relies on the DNS resolver functions that are standard installed on your system. The bad thing about these standard functions is that they are not very good, and they were never intended for high performance MTAs that do many DNS lookups at the same time. There is however also a nice thing about using the standard resolver functions: the DNS lookups of MailerQ return exactly the same results as the lookups done by system utilities like telnet, ping, openssl, dig, et cetera.
To work around the bad aspects of the standard resolver functions, MailerQ runs all DNS operations in seperate threads. By doing this, a slow DNS operation can never block or slow down other mail deliveries. The number of threads that MailerQ uses for the DNS lookups can be set in the config file using the "dns-threads" variable:
The management console has a special DNS widget that you can use to monitor how many DNS operations are in progress. If you see that the number of DNS operations is almost always higher than the number of threads, it is best to increase the number of threads. This will immediately improve your MTA's performance.
For the DNS lookups of IP addresses, MailerQ uses the standard "getaddrinfo" library call that is available on all Linux systems. This function checks the /etc/hosts and /etc/gai.conf files for your server's DNS settings and it sends a DNS query to a DNS server if necessary. This is exactly what you want.
However, this standard "getaddrinfo" function does not expose the time-to-live (TTL) value to its caller, which is needed to know for how long DNS results can be cached. MailerQ is therefore conservative and assumes that all TTL's are set to 60 seconds. This low TTL value causes a lot of unnecessary DNS lookups, because DNS queries are repeated every single minute, while in reality most TTL are set to a much higher values (for example 24 or 48 hours).
To prevent all these extra DNS lookups, you can instruct MailerQ to forget about the "getaddrinfo" function and send queries to DNS server directly. If MailerQ does this, it will have access to the real TTL value, and can cache the DNS results for a much longer time. You can disable the "getaddrinfo" calls with the following config file setting:
There is however a downside here. If the getaddrinfo function is not used, MailerQ will also not check the /etc/hosts and /etc/gai.conf file, and you run the risk that MailerQ's DNS lookups return different results than the lookups of system utilities.
Every couple of minutes, MailerQ reloads all its information from the database, and validates all the DKIM keys in the database by matching the public key found in DNS with the private key in the database. If you have a lot of DKIM keys in your database, this could take a very long time because the DNS lookups are slow and MailerQ can only run one at a time. If you want to speed this up, you can start special DNS threads that are only used when DKIM keys are being reloaded. This allows MailerQ to run many lookups in parallel. The number of threads can be set in the config file:
These threads only run during the short period of time that DKIM keys are loaded from the database.
One of our favourite tools in MailerQ is tags. With tags, you can do a lot on an individual delivery level - or on any level ...
We are excited to announce the latest version of MailerQ - version 5.5 - which includes improved insights into deliveries that are sch...